Add a KB Controller via Scan

Add a KB Controller via Scan

1.0 Introduction

  1. From the main menu, click on Hubs.



  2. Your hub will appear in the list.
  3. Locate the Actions drop-down menu on the right, click the down-arrow and select Scan, or click the SCAN button.



  4. The scan function will scan the local network for KB controllers.

  5. After a few seconds, controllers will be displayed.

    Note: You may also see Keri NXT controllers appear, as they can co-exist on the same Borealis site.

  6. Place a check mark against the controllers that you wish to claim.
  7. Enter a name for each of the controllers that you wish to add.
  8. Then enter the static IP address you wish to assign the controller(s).

  9. Click the CLAIM button.

    CLAIM button

  10. At the top of the screen you should see a message stating that the controller has been successfully claimed.



  11. Go to Hardware >> Controllers and the new controllers will be listed.
  12. Initially you will see that the controllers have a status of Unknown.

  13. Please wait 1-2 minutes for KB controllers to come online.
  14. Once the status displays as online, the controllers are ready for use and further configuration.


Important Note: 
Once the controller is online, it is advisable to open live events to check if the controller requires a firmware upgrade.



Add a KB Controller Video





    • Related Articles

    • Add a KB Controller via Manual Add

      The following steps explain how to manually add a KB controller using the Borealis web client. Again, before manually adding KB controllers, you must already have the KB hub online and it must have completed its initial update: From the main menu, ...
    • Add a KB Controller Using the Connect App

      1.0 Introduction The Borealis Connect app has a QR Enroll function that allows you to quickly and easily enroll a new KB 2D/4D controller using the QR code that's printed on the controller. Again, this section assumes you have an existing Borealis ...
    • KB Controller Technical Overview

      1.0 Introduction The following document provides you with an overview of the KB controller integration with Borealis. The KB controller is a 2D or 4D controller built for Borealis. As well as all the essential features you would expect from an access ...
    • KB Controller - Full Setup Guide

      KB Controller Full Setup Guide (attached)
    • Entraguard Controller Setup in Borealis

      1.0 Introduction The following document explains how to setup an Entraguard controller in Borealis. Once a PXL (and Entraguard) hub has been claimed and auto-updated, you can then add an Entraguard primary controller or you can add the Entraguard as ...