Add an NXT 4x4 Module

                      

     

     

The NXT 4×4 module is added to the system via the controller section. The NXT 4x4 module is compatible with Standard NXT, Keri KB and NXT-MSC (Mercury-Powered) controllers.

Note: 
- It is not currently possible to link inputs to outputs or re-assign the inputs and outputs to door contact, RTE, strike functionality, etc. Currently, you have the ability to control the outputs on a 4x4 module via Borealis.

1. From the Borealis user interface, click on Hardware >> All.
   
2. Click the black down-arrow to expand the controller.
   
3. Click the black down-arrow to expand the Onboard DDM. The controller buses will then be displayed.
   
4. Select the bus that the 4x4 module is wired into.
   
5. Click the ADD 4X4 button.
   
   
   
   Note: If you are using NXT-MSC controllers you will also see an ADD READER button (giving you the option to add an NXT Exit reader.
   
   
6. Confirm the prompt that appears.
   
7. The NXT 4x4 module will be added to the selected bus.

• Related Articles

• Configure Door Functionality on an MR16 Module

  1.0 Introduction You can configure an MR16IN and an MR16OUT module with input and output door functions. For example; you can program inputs on the MR16IN to function as the door contact and the RTE inputs. You can also configure an MR16OUT output to ...

• NXT-MSC - MR16 Module Setup

  MR16OUT-S3 Module MR16IN-S3 Module 1.0 Introduction You can add Mercury MR16IN and MR16OUT modules to the RS-485 port of an NXT-MSC controller after configuring the controller port to the Mercury Security protocol. Each MR16IN or MR16OUT module has ...

• Configure Door Functions on a 4x4 Module

  1.0 Introduction You can configure a 4x4 module with input and output door functions. For example; you can program inputs on the 4x4 to function as the door contact and the RTE inputs. You can also configure a 4x4 output as a lock strike relay. This ...