Add a KB Controller Using the Connect App

Add a KB Controller Using the Connect App

1.0 Introduction

The Borealis Connect app has a QR Enroll function that allows you to quickly and easily enroll a new KB 2D/4D controller using the QR code that's printed on the controller. Again, this section assumes you have an existing Borealis System (with an online hub added to a KB site), and you are adding a new KB controller to that System.

 

Using the Connect app is a fail-safe method of manually adding controllers, as there is no possibility of inputting the MAC address incorrectly, and controllers can be added
directly from the location that the controller is physically installed. KB Controllers can also be manually added even if they are not powered-up.

 

Note: Optionally, you can manually add KB controllers using the web user interface

 

2.0 Install the Borealis Connect App

  1. Download and install the Borealis Connect app for your Android or iOS device. Search for 'Borealis Connect'.



  2. Tap the INSTALL button.
  3. The Connect app will install within a few seconds.
  4. A Borealis Connect icon will appear on your home screen.


 

3.0 Add a KB Controller Using QR Enroll

  1. Tap the Borealis Connect icon.
  2. Log in with your registered e-mail address and password.
  3. Once logged-in you will see the home screen.
  4. Select your Borealis System (which the KB hub is added to).



  5. Select the QR Enroll option.



  6. Confirm that you will allow the app to access the camera on your device.
  7. Go to the KB controller and scan the QR code located in the lower-right corner.



  8. Once scanned, the KB controller will be immediately added to the app.
  9. The exact controller model and MAC address will be detected and displayed.
  10. Enter the IP address that you wish to assign to the controller.

    Note: You may wish to involve the IT department (if applicable), to obtain an available static IP address to assign to the controller.

  11. Select the hub that you wish to add the controller to.
  12. Click the ADD button.



  13. The controller will now be added to the system and the specified IP address will be applied to the controller properties.
  14. Once KB controllers have been added via the app, a scan will still need to be performed via the KB hub (using the web client). This will assign the IP address to the controller to finalize the enrollment. After you have performed the scan the KB controller will show as online.



Add a Controller to Borealis Using the Connect App





    • Related Articles

    • KB Controller Technical Overview

      1.0 Introduction The following document provides you with an overview of the KB controller integration with Borealis. The KB controller is a 2D or 4D controller built for Borealis. As well as all the essential features you would expect from an access ...

    • Add a KB Controller via Manual Add

      The following steps explain how to manually add a KB controller using the Borealis web client. Again, before manually adding KB controllers, you must already have the KB hub online and it must have completed its initial update: From the main menu, ...

    • KB Controller - Full Setup Guide

      KB Controller Full Setup Guide (attached)

    • Add a KB Hub

      The following steps explain how to add and claim a hub. When adding the hub you will associate it with the KB site. Once the hub has been successfully claimed the hub will be configured for the KB hardware type. Notes: A hub configured for KB will ...

    • Add a Controller to Borealis

      Add a New Controller (NXT, KB or NXT-MSC) The process of adding a controller to Borealis is the same regardless of the controller type being installed (the steps apply to both NXT and NXT-MSC controllers). The only difference is that Standard NXT and ...