Add a Controller to Borealis

Add a New Controller (NXT, KB or NXT-MSC)

The process of adding a controller to Borealis is the same regardless of the controller type being
installed (the steps apply to both NXT and NXT-MSC controllers). The only difference is that
Standard NXT and Keri KB controllers must be manually assigned an IP address.

Note: The controllers must be added to the same DHCP-enabled and internet-enabled
network that the hub is connected to. The NXT-MSC controllers will obtain a DHCP address,
but the Standard NXT and KB controllers will be configured with a static IP address (prior to
claiming the controllers).

1. From the dashboard, click on Hubs.
   
2. Your hub will appear in the list.
   
3. Locate the Actions drop-down menu on the right, click the down-arrow and select Scan.
   
   
   
   
4. The scan function will scan the local network for controllers.
   
5. After a few seconds, controllers will appear in the list.
   
6. IMPORTANT NOTE: If you are adding NXT-MSC controllers they will be assigned with 
   a DHCP IP address. If you are adding Standard NXT or Keri KB controllers you will need to manually
   enter the IP address you wish to assign the controller(s).
   
   
7. Place a check mark against the controllers that you wish to claim.
8. Enter a name for each of the controllers that you wish to add.
   
   
   
   
9. Click the CLAIM button.
   
   
   
   
10. At the top of the screen you should see a message stating that the controller(s) has been
    successfully claimed.

• Related Articles

• Add a PXL Primary Controller to Borealis

  1.0 How Do I Add a PXL Controller? Once the PXL-configured hub has been claimed and updated, you can then add a PXL primary controller. A PXL primary is the first controller on the network (and is address #1). There are two methods for adding a PXL ...

• Add a KB Controller via Manual Add

  The following steps explain how to manually add a KB controller using the Borealis web client. Again, before manually adding KB controllers, you must already have the KB hub online and it must have completed its initial update: From the main menu, ...

• Entraguard Controller Setup in Borealis

  1.0 How Do I Add an Entraguard Controller? The following document explains how to setup an Entraguard controller in Borealis. Once a PXL (and Entraguard) hub has been claimed and auto-updated, you can then add an Entraguard primary controller or you ...

• Add a KB Controller via Scan

  1.0 Introduction From the main menu, click on Hubs. Your hub will appear in the list. Locate the Actions drop-down menu on the right, click the down-arrow and select Scan, or click the SCAN button. The scan function will scan the local network for KB ...

• Add a KB Controller Using the Connect App

  1.0 Introduction The Borealis Connect app has a QR Enroll function that allows you to quickly and easily enroll a new KB 2D/4D controller using the QR code that's printed on the controller. Again, this section assumes you have an existing Borealis ...